Error Mail

If the ixi-UMS MDS shall send an e-mail when an error is recognized, a sender, a recipient and the respective ixi-UMS Connector directory have to be entered here.

The e-mail is sent with the following problems:

·Error with reading our a server directory

·Error with reading our an In.directory (within the server directory)

·In case of a system error with subsequent automatic restart of the MDS

·Error with the inbound file transfer (download, deletion of the file at the ixi-UMS Kernel Server)

·When no routes are defined with the start of the ixi-UMS MDS

·When the local Connector Root directory cannot be read out

·When a job could not be routed and was shifted to the respective "NoRoute"-directory

·When at a location, no valid server entry is available

·Error with the outbound file transfer (to the ixi-UMS Kernel Server)

Please note that most of the problems listed above do not affect the functionality of the ixi-UMS MDS in general but are only network problems that occur temporarily.  

In order to receive an e-mail notification it has to be determined, in which Connetcor-directory it shall be created. The directory of an installed ixi-UMS Connector has to be stated.

The e-mail addresses of the sender and the recipient as well as the text of the e-mail are freely selectable and can be changed at any time. The same text as above will always be sent - no matter what error the mail was generated due to. More detailed information about the cause of the error can be found in the log and in the event.

An e-mail notification is generated only once! Once the email has been sent, it must be resent by clicking the "Reset email error" button or restarting the service.