Configure ISDN connection

IMPORTANT: The device must be connected with an active and configured connection of the phone arrangement / NTBA.

ISDN-Port1_en

Open the Menue „Physical Interfaces“ and select „ISDN-Ports“. Depend on the device you can see „BRI“ ans/or „PRI“-Ports.

Note:

Normally the ports on "automatic" recognition are put. If the device was restarted after the connection of the ISDN management and the connection was recognised, this is already indicated you under "ISDN Switch type".

In this case you can ignorethe next step. If the connection was not recognised (e. g. because as a protocol Q-SIG“ is furnished), you must configure the connection manualy.

Select WerzeugButton Symbol beside the desired connection.

ISDN-Port2_en

Unmark the option "Autoconfiguration on Bootup"

As „Port-Usage“ select:

Dialup (Euro-ISDN)

If the connection with PBX is a Point-to-Multipoint or Point-to-Point with DSS1

or you use an NTBA/Primärmultiplexer (S2M)

Q-SIG

If the connection with PBX use the Protokoll Q-SIG.

In „ISDN-Configuration Type“ select:

Point-to-Multipoint

Called Party Number in accordance with ETSI ETS 300 102-1: 4.5.8 complete in Setup Message 3.1.16 or in accordance with ITU Q.931: 4.5.8 complete in Setup Message 3.3.9

Point-to-Point

PP means that Overlap Receiving is enabled in accordance with ETSI ETS 300 102-1:

2.1.1.16 as well as 2.1.2.17 or in accordance with ITU Q.931: 5.1.3

- CalledPartyNumber in accordance with ETSI ETS 300 102-1: 3.1.16 or in accordance with ITU Q.931: 4.58

Note:

If you select „Point-to-Point, a new line " P-P Base Number" is indicated. Please don't type in anything !

Click on OK to store the settings

Change to MSN Configuration – also if the connection recognised be reboot.

ISDN-Port3_en

Normally there is no entry. Click on "New" to provide an entry.

The following configuration are independent of the connection. You need to configure always.

ISDN-Port4_en

ISDN-Port	Select the used ISDN Port	The adjustment in„MSN-Recognition“ depents of the connection type.
Dienst	ISDN-Login	Right to Left	If you use a Point-to-Mutlipoint connection
MSN	999999	Left to Right (DDI)	If you use a Point-to-Point connection

Bearer Service set to " Data + Voice

Save the configuration with "OK"

At the end select "save Configuration" on the left side about the menu .

Recommendation – but not compelling necessarily: Now they should restart the device!

After that check the Status of the Connection

ISDN-Port5_en_kl

Version 7