General Dial ISDN

Tracelevel=0

The tracelevel for the MWI-module is set here. This value is 0 by default and should only be changed upon advice of %Firma% GmbH.

0 = no trace

1 to 250 trace with more or less details; recommended 0 or 200

           e.g. Tracelevel=200

           Default: 0

Compatmode=0

This value determines in which form the ixi-UMS Kernel processes the MWI messages. Basically, the option "Compatmode=0" should be selected. In this way, the MWI messages from the messaging system can easily be set with 1 or 0.

Note: The Compatmode=1 is only used in special configurations

Compatmode 1 = compatbility/emulation with/of Infotext/"Assoziierte Dienste"

;                set infotext with <OnPrefix><Dest><OnPostfix>

;                clear infotext with <OffPrefix><Dest><OffPostfix>

;                0 = MWI mode

;                set MWI with 1<Dest>

;                clear MWI with 0<Dest>

OnPre=7568

Code number for "MWI on"

OnPost=1

OnPostfix

OffPre=7668

Code number for "MWI off"

OffPost=

OffPostfix

OffInsertDest=0

1,0 Determination how the dialing information is created

OffinsertDest = 1

MWI ON : <OnPre><Destination><OnPost>

MWI OFF: <OffPre><Destination><OffPost>

OffinsertDest = 0

MWI ON: <OnPre><Destination><OnPost>

MWI OFF:<OffPre><OffPost>

CtrlNum=1

Here the wanted Controller needed for the setting of MWI messages is entered. All the MWI signalings are transmitted via this Controller. It is not possible to state more than one Controller.

CallingPTY

Optional; overrids the CallinPartyNumber provided in the job file. A default sender number can be deposited here. This number overrides existing sender numbers in the Alert jobfile, if applicable, and then is valid for every user. The UMS recipient number or the MWI sender number desposited at the user is sent to the telephone as sender number by default.