Installation instructions
To install estos MetaDirectory run this MSI setup. A wizard will guide you through the installation process.
|
A server account in the estos UCConnect is required for the installation and operation of the estos UCServer. The estos MetaDirectory must be able to connect to UCConnect during installation and be permanently connected during operation. Information about the shares required in the firewall can be found at the bottom of the page.
|
- Clicking on the estos MetaDirectory_xx-XX.msi will start the server installation.
- After the Welcome page, the license terms are displayed.
- Read and confirm the license agreement.
- On the next page the ServerID and the corresponding password from the server account in the estos UCConnect must be specified.
- In the next step it is checked whether the version can be installed and the result is output. For this in the UCConnect is checked whether a valid license for this version is registered, and/or whether there is a valid software maintenance contract (SPV).
- Next, the installation folder must be specified. After that the installation of the estos MetaDirectory can be started.
- After the installation the estos UCServer setup starts automatically to query the most important settings.
Connection to estos UCConnect
The following list shows what must generally be set up in the routers/firewalls. The routers/firewalls must be set up so that once a connection has been established, it remains open and all additionally required/requested ports can be used.
Source |
UCServer |
Destination |
*.ucconnect.de |
Port |
443, TCP |