Configure Network Routing Service
The connection to the telephone system can be made through the Network Routing Service (NRS). This requires the CS1000 node and the ECSTA driver to be configured as Gateway Endpoints in the corresponding Service Domain.
Configuration details for Avaya CS1000 Version 6.5 and earlier versions
- Open the Network Routing Service Manager.
Navigate to the Network Routing Service in CS1000 Element Manager and open the Network Routing Service Manager. Enter user name and password.
- Switch to Standby DB view
In order to add a Gateway Endpoint or to change settings, this must be done in the mode standby DB view.
- Navigate to Configuration - Gateway Endpoints
Select the Service Domain to be used. Press 'Show'.
- Check the Gateway Endpoint for the ECSTA Drivers
You need a Gateway Endpoint to add ECSTA drivers.
Endpoint Name | ecsta (ECSTA Gateway sip URI user part) |
Endpoint authentication enabled | Not configured |
Static endpoint address type | IP version 4 |
H.323 Support | H.323 not supported |
SIP support | Dynamic SIP endpoint |
SIP transport | TCP |
SIP port | 5260 (ECSTA TCP Listen Port) |
- Save the changes
Under Tools - Database Actions, run 'Cut over and Commit.'
Configuration details for Avaya CS1000 Version 7.0 and later versions
- Open the Networks Routing Service Manager
Navigate in the CS1000 Element Manager to Network Routing Service and open the Network Routing Service Manager. Log on.
- Open the End Points view under Numbering Plans.
To add a gateway endpoint or to change settings, the Managing mode must be set to the Standby Database Mode. Add a new endpoint under the Gateway Endpoints item.
- Configure the new gateway endpoint as follows:
Endpoint Name | ecsta (ECSTA Gateway sip URI user part) |
Endpoint authentication enabled | Authentication off |
Static endpoint address type | IP version 4 |
H.323 Support | H.323 not supported |
SIP support | Dynamic SIP endpoint |
SIP mode | Proxy mode |
SIP TCP transport enabled | activate |
SIP TCP port | 5260 (ECSTA TCP Listen Port) |
- Save the changes
Save the settings for the gateway endpoint
Execute the Cut Over and then the Commit menu options under System Database.