On the device must installed the firmwae or newer and must set in "PBX-Mode".


1.A „bintec elmeg be.IP plus“ with integrated DSP

Open the Configuration and navigate to „System Management – Status“ . In section "Moduls" you can see the installed DSP modules. If this information not present you can't use this device with ixi-UMS





2.Outside Line

The PBX must be connected to a SIP Provider. The conencttion properties must be known!

(See ixi-UMS_TK-Konfigblatt.pdf)



A user must be put on for every phone number/DDI and for every Fax-Voice-number/DDI.




The desired Fax/Voice numbers must be assigned to the interface "CAPI". -> Moreover you find explanations under Configuration be.IP plus.



Version 6